Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

General Information 00 COE Cab Tilting, FLA/FLB: 00–11 velocity fuses have locked up the tilt cylinders; unlock them. 6. To tilt the cab all the way, continue working the pump until the cab nears a 45-degree angle. Re- duce pumping speed. Once the cab goes beyond 45 degrees, stop working the pump. The cab will gently descend to a full-tilt position. To stop the cab at any position between 45-degrees and full- tilt, move the control lever to "Lower." WARNING Make sure the tilt strut is pushed down onto the right tilt-cylinder rod. If the tilt strut is not en- gaged, and the cab drops, the result could be seri- ous injury or death. IMPORTANT:

If the cab unintentionally stops after it has gone beyond 45 degrees, do not force it down with the tilt pump. The velocity fuses have locked the tilt cylinders; unlock them. 5. When the cab reaches a 30-degree angle, stop working the pump. Push the free end of the tilt strut down onto the right tilt-cylinder rod. See Fig. 5 . The tilt strut prevents the cab from acci- dently dropping below this position. Returning the FLB Cab from the Tilted Position DANGER Stay completely clear of the cab’s travel path at all times. Once the tilt strut has been released, do not lean over the frame rails, the engine, or the transmission for any reason. To do so could result in serious injury or death. 1.

Move the tilt strut away from the right tilt-cylinder rod, and lock it in the spring catch. If the cab was tilted less than 45 degrees, raise it enough to release the tilt strut. Move the tilt strut away from the tilt-cylinder rod, and lock it in the spring catch before lowering the cab. See Fig. 6 . 07/26/93 f310360a Fig. 4, Cab Latch Indicator Pin 1 2 1 3 2 04/15/93 f310357a 04/15/93 f310358a 1. Tilt-Cylinder Rod 2. Tilt Strut 1. Tilt Strut 2. Tilt-Cylinder Rod 3. Tilt Cylinder Fig. 5, Tilt Strut Positioning Fig. 6, Releasing the Tilt Strut Heavy-Duty Trucks Maintenance Manual, October 2009 00/21