General Information 00 COE Cab Tilting, FLA/FLB: 00–11 2. Set the pump control lever at "Lower," and work the pump until the cab nears a 45-degree angle. Reduce pumping speed. Once the cab goes over center, stop working the pump. The cab will gen- tly descend to the operating position. WARNING Before tilting the cab, make sure that there is ad- equate clearance in front of the vehicle, and that the area is free of people and all objects. To stop the cab at any position between 45 de- grees and 30 degrees, move the control lever to "Raise," and push the tilt strut down onto the right tilt-cylinder rod. Do not tilt the cab with the engine running. Tilting the cab could engage the transmission.
If the en- gine is running, the vehicle can move, causing an accident that could result in personal injury or property damage. IMPORTANT: If the cab unintentionally stops after it has gone beyond 45 degrees, do not force it down with the tilt pump. The tilt strut is in the locked position, or the velocity fuses have locked the tilt cylinders. Release the tilt strut, or unlock the velocity fuses. 2. Remove the pump handle from the baggage compartment, and insert it into the pump shank. 3. Secure all loose articles in the cab and bunk, and make sure the doors are securely latched. 3.
When the cab is lowered all the way, make sure the pump control lever is set at "Lower." WARNING Objects falling in the cab, or a door flying open, could damage the vehicle or cause personal in- jury. 4. Check the indicator pin on each cab latch. See Fig. 4 . The latches are locked when the pins have moved back into the piston and cylinder spring assembly. 4. Move the pump control lever to "Raise." 5. Push the transmission shift lever forward to lock the shift tube latch mechanism. NOTE: Maintain the hydraulic fluid level at the oil fill plug. Add fluid only when the cab is in the operating position. Use only Freightliner- approved hydraulic fluid; see Group 60 for specified fluid. 5.
Unlock the back-of-cab latch handles ( Fig. 7 ) by pulling them outward. See Fig. 8 . Tilting the FLA Cab CAUTION Before tilting the cab, make sure the vehicle is parked on level ground, both side-to-side and front-to-rear. Tilting the cab while the vehicle is parked on unlevel ground (such as a sloping high- way shoulder) may damage the cab mounts and prevent you from returning the cab to the operat- ing position. f310039 07/22/93 Fig. 7, Latch Handle (Locked Position) 1. Apply the parking brakes. Place the transmission shift lever in neutral. Shut down the engine if it is running. CAUTION Do not work the tilt pump while the cab latches are locked.
Doing this causes stress in the back of the cab, which could cause rivet and cab-skin damage. Heavy-Duty Trucks Maintenance Manual, October 2009 00/22