General Information 00 COE Cab Tilting, FLA/FLB: 00–11 system; for instructions, see Group 60 of the Heavy-Duty Trucks Service Manual. If the cab stops moving while it is being raised, do not force it to move with the tilt pump. The velocity fuses have locked up the tilt cylinders; unlock them. 7. After the safety hook has been raised above the safety catch ( Fig. 10 ), let go of the release handle. Tilt the cab to a 30-degree angle. f310040 07/22/93 Fig. 8, Latch handle (Unlocked Position) 6. Pull the safety hook release handle ( Fig. 9 ) while working the hydraulic pump. If the cab does not begin to raise during the first 10 to 15 strokes, stop what you are doing.
Make sure the shift tube latch mechanism has released. 1 2 07/22/93 f310042 1. Safety Catch 2. Safety Hook Fig. 10, Safety Catch Mechanism WARNING Make sure the tilt strut is pushed down onto the right tilt-cylinder rod. If the tilt strut is not en- gaged, and the cab drops, the result could be seri- ous injury or death. 8. When the cab reaches a 30-degree angle, push the free end of the tilt strut down onto the right tilt-cylinder rod. See Fig. 11 . The tilt strut pre- vents the cab from accidently dropping below this position. f310041 07/22/93 Fig. 9, Safety Hook Release Handle 9. To tilt the cab all the way, continue working the pump until the cab nears a 45-degree angle.
Re- duce pumping speed. Once the cab goes beyond 45 degrees, stop pumping. The cab will gently descend to a full-tilt position. To stop the cab at any position between 45-degrees and full-tilt, move the control lever to "Lower." CAUTION Continued application of force to tilt the cab when the shift tube latch mechanism has not released could result in transmission or shift tube damage. NOTE: If air is present in the hydraulic tilt sys- tem, pump operation will seem "spongy" or inef- fective. If this happens, bleed the air from the IMPORTANT: If the cab unintentionally stops after it has gone beyond 45 degrees, do not Heavy-Duty Trucks Maintenance Manual, October 2009 00/23