General Information 00 COE Cab Tilting, FLA/FLB: 00–11 2 1 1 3 2 07/21/93 f310043 1. Tilt-Cylinder Rod 2. Tilt Strut 07/22/93 f310044 Fig. 11, Tilt Strut Positioning 1. Tilt Strut 2. Tilt-Cylinder Rod 3. Tilt Cylinder force it down with the tilt pump. The velocity fuses have locked the tilt cylinders; unlock them. Fig. 12, Releasing the Tilt Strut IMPORTANT: If the cab unintentionally stops after it has gone beyond 45 degrees, do not force it down with the tilt pump. The tilt strut is in the locked position, or the velocity fuses have locked the tilt cylinders. Release the tilt strut, or unlock the velocity fuses. Returning the FLA Cab from the Tilted Position DANGER 3.
When the cab is lowered all the way, make sure the pump control lever is set at "Lower." Stay completely clear of the cab’s travel path at all times. Once the tilt strut has been released, do not lean over the frame rails, the engine, or the transmission for any reason. To do so could result in serious injury or death. 4. Lock the cab latch handles. See Fig. 7 . Make sure the cab latch hooks have engaged the U-bolts on the cab mounts, and that each latch handle lockpin is engaged. 1. Move the tilt strut away from the right tilt-cylinder rod, and lock it in the spring catch. 5. Remove the pump handle from the pump shank. Mount the handle in the baggage compartment.
If the cab was tilted less than 45 degrees, raise it enough to release the tilt strut. Move the tilt strut away from the tilt-cylinder rod, and lock it in the spring catch before lowering the cab. See Fig. 12 . 6. Push the transmission shift lever forward to lock the shift tube latch mechanism. NOTE: Maintain the hydraulic fluid level at the oil fill plug. Add fluid only when the cab is in the operating position. Use only Freightliner- approved hydraulic fluid; see Group 60 for specified fluid. 2. Set the pump control lever at "Lower," and work the pump until the cab nears a 45-degree angle. Reduce pumping speed. Once the cab goes over center, stop pumping.
The cab will gently de- scend to the operating position. To stop the cab at any position between 45 de- grees and 30 degrees, move the control lever to "Raise," and push the tilt strut down onto the right tilt-cylinder rod. Heavy-Duty Trucks Maintenance Manual, October 2009 00/24