General Information 00 Noise Emission Controls Maintenance: 00–12 General Information the purpose of noise control, prior to its sale or delivery to the ultimate purchaser, or while it is in use. Federal Law, Part 205: Transportation Equipment Noise Emission Controls 2. The use of the vehicle after such device or ele- ment of design has been removed or rendered inoperative by any person.
Part 205, Transportation Equipment Noise Emission Controls, requires the vehicle manufacturer to fur- nish, with each new vehicle, such written instructions for the proper maintenance, use, and repair of the vehicle by the ultimate purchaser to provide reason- able assurance of the elimination or minimization of noise-emission-control degradation throughout the life of the vehicle. In compliance with the law, the noise emission controls maintenance information in each applicable group of this manual, in conjunction with the vehicle service manual, provides these in- structions to owners.
Recommendations for Replacement Parts Among those acts presumed to constitute tam- pering are the acts listed below: A. Removal of engine noise-deadening panels. B. Removal of cab-tunnel or hood noise- deadening panels. C. Removal of, or rendering inoperative, the en- gine speed governor so as to allow engine speed to exceed manufacturer’s specifica- tions. D. Removal of, or rendering inoperative, the fan clutch, including bypassing the control on any thermostatic fan drive to cause it to op- erate continuously. Replacement parts used for maintenance or repair of noise emission controls should be genuine Freight- liner parts.
If other than genuine Freightliner parts are used for replacement or repair of components affecting noise emission control, the owner should be sure that such parts are warranted by their manufac- turer to be equivalent to genuine Freightliner parts in performance and durability. Freightliner Noise Emission Controls Warranty E. Removal of the fan shroud. F. Removal of, or rendering inoperative, ex- haust components, including exhaust pipe clamping. Maintenance Instructions G. Removal of air intake components. Scheduled intervals are in the maintenance tables in this group.
A "Verification of Inspections Log (Groups 01, 20, and 49)" follows, and should be filled in each time noise emission controls on the vehicle are main- tained or repaired. Refer to the vehicle owner’s warranty information book for warranty information concerning noise emis- sion controls. Tampering with Noise Controls is Prohibited Federal law prohibits the following acts or the caus- ing thereof: 1. The removal or rendering inoperative by any per- son (other than for purposes of maintenance, repair, or replacement) of any device or element of design incorporated into any new vehicle for Heavy-Duty Trucks Maintenance Manual, October 2009 00/25