Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Engine 01 01–01 Engine Rear-Support Assembly Checking (Noise Emission Control) 2 3 Front and rear engine supports for vehicles built from January 2007 require no periodic maintenance. Mounts should be inspected when the engine is re- moved for service. For vehicles manufactured prior to January 2007, perform the following check. 1 4 Visually inspect the rubber isolators (see Fig. 1 , Ref. 7 for an FLA, FLB, or FLD; Fig. 2 , Refs. 4 and 6 for an FLC) for cracks, cuts, and other damage; replace if damaged. Also, at engine overhaul or whenever the engine has been removed, replace the isolators. See Group 01 of the Heavy-Duty Trucks Service Manual for isolator replacement procedures.

5 1 5 2 6 6 7 f010648 01/16/96 3 1. Overslung Crossmember 2. Engine-Support Bolt 3. Transmission-Mounted Engine-Support Bracket 4. Upper Isolator 5. Frame-Mounted Engine-Support Bracket 6. Lower Isolator 7. Engine-Support Stop Nut f010155a 05/27/93 1. Frame Rail 2. Upper Mounting Bolt, Nut, and Washers 3. Lower Mounting Bolt, Nut, and Washers 4. Engine Rear Support Bolt and Washer 5. Engine Leg 6. Snubbing Washers or Wear Plate(s) 7. Rubber Isolator 8. Locknut, Washer, and Snubbing Washer 9. Engine Mount 10. Spacer(s) Fig. 2, Engine Rear-Support Assembly, FLC Fig. 1, Engine Rear-Support Assembly, FLA, FLB, and FLD Check the engine rear-support fasteners for tight- ness. See Fig.

1 for an FLA, FLB, or FLD, or Fig. 2 for an FLC. See Table 1 for torque specifications. Heavy-Duty Trucks Maintenance Manual, January 2007 01/1 4 7 8 9 10