Engine 01 Rear Engine-Support Fasteners Torque Specifications Description Size Grade Torque * : lbf·ft (N·m) Rear Engine-Support-Isolator Nut, FLA, FLB, and FLD 5/8–11 C 160 (216) Rear Engine-Support-Isolator Stop Nut, FLC 1.00–8 B 280–380 (380–515) Frame-Mounted Engine-Support-Bracket Nut 5/8–11 C 190 (258) Transmission-Mounted Engine-Support-Bracket Capscrew, FLC 3/4–10 8 340 (461) Overslung Crossmember Nut, FLC 1/2–13 C 95 (129) * Torque values are for dry, unplated fasteners. Table 1, Rear Engine-Support Fasteners Torque Specifications 01–02 Engine Noise Panel Inspecting (Noise Emission Control) If so equipped, inspect for torn engine noise panels. See Fig.
3 for a Caterpillar engine, or see Fig. 4 for a Cummins engine. If panels are torn, replace them with new panels; see Group 01 of the Heavy-Duty Trucks Service Manual for procedures. Cummins M11 and N14 engines, and Detroit Diesel Series 55 and Series 60 engines do not have engine noise panels. 1 01–03 Jacobs Engine Brake Wiring Inspecting 05/27/93 f010647a Inspect the wiring from the dash switches to the en- gine brake housings for breaks and for broken or chafed insulation. Make sure that all terminal connec- tions are in good condition and are fastened. Inspect the wiring to the clutch and throttle switches.
See Group 01 of the Heavy-Duty Trucks Service Manual for the engine brake wiring diagram. NOTE: Some engine brake installations do not use clutch or throttle switches. NOTE: Caterpillar 3406E engines do not have right-side noise panels. 1. Right-Side Noise Panel 2. Oil Pan Noise Panel 3. Left-Side Noise Panel Fig. 3, Caterpillar Engine Noise Panels serpentine belts are retained by a belt tensioner that requires no tension adjustment. Replace the engine drive belt if any conditions described in the visual description are found. V-belts are installed as indi- vidual belts, and as matched sets. When replacing a matched set of belts, always replace both belts at the same time.
Matched belts must be from the same manufacturer. To inspect a belt, gently twist the belt to view the belt sidewalls and bottom. Visually in- spect all drive belts for the following conditions, then perform the belt tension inspection: 01–04 Engine Drive Belt Inspecting Worn or loose drive belts may cause premature bearing failure or engine overheating. Excessive ten- sion, or too little tension on the belt may result in ex- cessive and premature belt wear. Poly-V belts, or Heavy-Duty Trucks Maintenance Manual, January 2007 01/2 3