Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Engine 01 replacing the drive belts. Do not use belt dress- ing on any belt. 3. Check the belt for a jagged or streaked sidewall. See Fig. 5 , Ref. C. Jagged or streaked sidewalls are the result of foreign objects, such as sand or gravel in the pulley, or a rough pulley surface. 3 4. Check for tensile breaks; breaks in the cord body. See Fig. 5 , Ref. D. Cuts in a belt are usu- ally caused by foreign objects in the pulley, or by prying or forcing the belt during removal or instal- lation. 1 5. Check for uneven ribs on serpentine (poly-V) belts. See Fig. 5 , Ref. E. Foreign objects in the pulley will erode the undercord ribs, causing the belt to lose its gripping power. 2 6.

Check the drive belts for cracks. See Fig. 5 , Ref. F. Small irregular cracks are usually the signs of an old belt. 4 4 7. Visually inspect the pulleys for excessive play or wobble. Excessive play or wobble indicates a failure of the pulley bearing. Check for belt squealing or squeaking. Replace the bearings as necessary. NOTE: If it is difficult to distinguish the location of a supposed bearing noise, place a stetho- scope on the component being checked, not the pulley, to isolate the area from outside interfer- ence. 8. Inspect all pulleys for foreign objects, oil, or grease in the grooves. Belt Tension Inspection 01/16/96 f010646a 1. NTC Right-Side Noise Panels 2.

NTC Oil Pan Noise Panel 3. NTC Left-Side Noise Panel 4. L10 Front Gear Cover Noise Panel NOTE: If engine drive belts require adjustment, see Group 01 of the Heavy-Duty Trucks Service Manual. Fig. 4, Cummins Engine Noise Panels Visual Inspection Threaded-Adjustment Type 1. Inspect the belt for glazing. See Fig. 5 , Ref. A. Glazing is represented by shiny sidewalls, and is caused by friction created when a loose belt slips in the pulleys. It can also be caused by oil or grease contamination on the pulleys. 1. Apply the parking brakes, and chock the tires to prevent the vehicle from moving. 2. Install a belt tension gauge at the center of the belt’s longest free-span. Check belt tension.

See Table 2 for belt tension specifications. 2. Check the belt for ply separation. See Fig. 5 , Ref. B. Oil, grease, or belt dressing can cause the belt to fall apart in layers. Repair any oil or coolant leaks that are affecting the belts before 3. If belt tension is not correct, see Group 01 of the Heavy-Duty Trucks Service Manual to adjust belt tension. Heavy-Duty Trucks Maintenance Manual, January 2007 01/3