Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Engine Cooling/Radiator 20 20–01 Radiator Cap Checking cable engine manufacturer’s maintenance and operation manual. WARNING 1. If necessary, remove the aerodynamic cover from the front bumper. Do not remove or loosen the radiator cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 2. Drain the radiator as follows: For a low-flow cooling system, disconnect the radiator bottom tank inlet and outlet hoses, and tighten the radiator cap.

Attach the flushing gun nozzle to the outlet hose. For a high-flow cooling system, disconnect the radiator upper and lower hoses, and tighten the radiator cap. Attach the flushing gun nozzle to the lower hose. CAUTION The radiator cap currently installed may not be the same one installed when the vehicle was built. If the radiator cap must be replaced, make sure that it is the correct cap for the cooling system of the vehicle. Because the radiator cap pressure rating affects the operating temperature of the engine, installing an improperly rated radiator cap may have adverse effects on the cooling system, and engine operating temperatures. This could cause premature engine wear or damage. 3.

Run the water until the radiator is full. CAUTION Excessive pressure can damage the radiator or heater core. 4. Gradually, apply air pressure to help dislodge sediment built up in the radiator core. Do not apply more than 15 psi (103 kPa) air pressure to the radiator. Pressures exceeding 15 psi (103 kPa) could damage the radiator core. 1. Using a radiator-cap tester, check the pressure cap to see if it maintains pressure to within 10 percent of the pressure rating marked on the cap. If it doesn’t, replace the cap. Make sure that the replacement radiator cap is correctly rated for the cooling system of the vehicle. 5.

Shut off the air at the pressure gun nozzle and allow the radiator to refill with water. 6. Repeat the previous two steps until clean water flows from the radiator. 2. There is a second valve in the radiator cap that opens under vacuum. This prevents the collapse of hoses and other parts that are not internally supported when the system cools. Inspect the vacuum-relief valve to be sure it is not stuck. 7. Remove the radiator side tank drain plug and allow the radiator to drain. Install and tighten the side tank drain plug and the radiator outlet pipe drain plug after the radiator has been drained. Do not overtighten the plugs. 3.

Make sure that the cap seals properly on the coolant filler neck seat, and that the radiator cap gasket is not damaged. On vehicles with screw on caps with O-rings, make sure that the O-ring is not cracked or deteriorated. Replace the cap if the gasket shows deterioration or damage. 8. Connect the hoses. Your hose clamps can be either T-bolt clamps (see Fig. 1 ) or Breeze Constant-Torque clamps (see Fig. 2 ). When working with T-bolt hose clamps, tighten the clamps 55 lbf·in (620 N·cm). These clamps are now standard on hoses with an inside diam- eter greater than 2 inches (51 mm).

20–02 Radiator Pressure Flushing and Coolant Changing When installing Breeze Constant-Torque hose clamps, the clamps must be tightened to the cor- rect torque. The screw tip of the clamp must ex- tend about 1/4 inch (6 mm) from the clamp hous- ing, and the belleville washer stacks must be collapsed almost flat. Use a torque wrench to NOTE: For additional instructions on cleaning and flushing the cooling system, see the appli- Heavy-Duty Trucks Maintenance Manual, January 2007 20/1