Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Engine Cooling/Radiator 20 install these clamps correctly. Correct installation torque for Breeze Constant-Torque hose clamps is: pressure. During vehicle operation and shut- down, the screw tip may adjust according to temperature and pressure changes. The torque may need to be adjusted for individual applica- tions. For clamps with a 5/16-inch tightening screw hex: 55 lbf·in (620 N·cm). For clamps with a 3/8-inch tightening screw hex: 90 lbf·in (1020 N·cm). IMPORTANT: On vehicles with EPA07 compliant engines, the coolant capacity varies depending on the engine and accessory installation.

After servicing the cooling system, always verify that the coolant level is between the MIN and MAX lines on the surge tank. 9. Fill the radiator with new coolant. See Group 20 of the Heavy-Duty Trucks Service Manual for guidelines. See Table 1 for FLA, FLB, and FLD 120 cooling system capacities, Table 2 for FLC 112 cooling system capacities, Table 3 for FLD 112 cooling system capacities. See Table 4 for antifreeze protection information. Certain equip- ment such as fuel heaters, water filters and auxil- iary heaters may increase the coolant capacity and require additional coolant. The cooling sys- tem is filled when the coolant level reaches the MAX line on the surge tank.

Freightliner recom- mends the use of a precharged and premixed antifreeze when refilling the cooling system. See Table 4 for a list of some of the precharged anti- freeze available. Use of an equivalent antifreeze to those listed in the table is also acceptable. Always check that the antifreeze used meets Freightliner’s specifications and is at the proper concentration for protection in the vehicle operat- ing area. See Table 5 for antifreeze protection information.

Freightliner specifies that the anti- freeze must be an ethylene glycol solution that meets GM 6038 M Engineering Standards or a ethylene glycol solution that has less than 0.1% anhydrous sodium metasilicate, and meets either GM 1825 M or GM 1899 M Engineering Stan- dards. If supplemental coolant additives are being used, add the supplements to the coolant as necessary. See the coolant additive manufac- turer’s instructions for the correct amount of addi- tive required. Don’t forget to consider the volume of the supplemental coolant additive being added to the system when determining the amount of coolant required to refill the system. 02/28/96 f200326 Fig.

1, T-Bolt Type Hose Clamp A B 1 08/15/94 f200286 A. The screw tip must extend about 1/4 inch (6 mm). B. The belleville washer stacks must be collapsed almost flat. 1. Tightening Screw Hex Fig. 2, Breeze Constant-Torque Hose Clamp Installation NOTE: All hose clamps will lose torque after installation due to "compression set." However, when correctly installed, Breeze Constant- Torque clamps will hold enough torque to auto- matically adjust and keep consistent sealing Heavy-Duty Trucks Maintenance Manual, January 2007 20/2