Engine Cooling/Radiator 20 1. Disconnect the batteries at the negative termi- nals. Drain all air from the air system. If equipped with an air starter, drain the air starter reservoir. If the fan clutch does not operate correctly, see Group 20 of the Heavy-Duty Trucks Service Manual for troubleshooting and repair proce- dures. 8. With the air system charged to 120 psi (827 kPa), check the fan clutch for audible air leaks, using a suitable listening device. WARNING Make sure the batteries are disconnected before checking the fan clutch. If the engine starts during this procedure, the fan could engage, which could result in serious personal injury.
Check at the solenoid valve, the air filter assem- bly, and the air hoses and fittings. See Fig. 9 . Using a wet finger or a soapy water solution, check for a leak in the same areas. 2. Inspect the electrical connections and wires to the fan clutch solenoid. Secure the connection if loose; replace wires and connectors if damaged. 3. Clean the fan clutch air solenoid valve filter, if equipped. 3.1 Unscrew the fan clutch solenoid valve air filter assembly and remove the filter ele- ment. 3.2 Clean the filter element with cleaning sol- vent. 3.3 Using a clean, lint-free cloth, wipe off any excess solvent. 3.4 Reassemble the clutch valve solenoid air filter assembly and install it on the ve- hicle.
f200581 05/30/2002 4. Check the fan for bent, cracked, or damaged blades; replace if damaged. Check for adequate clearance between the fan and other compo- nents. Fig. 9, Checking for Air Leaks (Horton DriveMaster) 9. If a leak is detected, remove the fan blade. In- stall a new seal kit. See Group 20 of the Heavy- Duty Trucks Service Manual for repair proce- dures. 5. Check the fan belt for wear, tension, and align- ment. Correct if necessary. 6. Check for wear on the friction facing. Replace the friction facing if it is worn to a 3/16-inch (4.8- mm) thickness or less. Also check the facing for signs of oil contamination or burn marks.
If evi- dence of oil or burn marks are found, replace the friction facing. 10. Check the fan drive for discoloration or any other signs of slipping or overheating. NOTE: The fan clutch may slip if the air supply pressure is below 70 psi (483 kPa) or if there is a leak inside the fan clutch. Any leak must be remedied. 7. Connect the battery cables. Start the engine, and charge the air system to 120 psi (827 kPa). Manually engage and disengage the fan clutch. 11. Check the fan clutch bearings. 11.1 Turn the fan in both directions and feel for worn hub bearings. Check the fan and the fan clutch from a dis- tance.
Look for vibration, fan blade contact, fan clutch slippage, and overall fan clutch operation. 11.2 If possible, remove the drive belt and check for worn sheave bearings by turn- ing the sheave in both directions. Heavy-Duty Trucks Maintenance Manual, January 2007 20/10