Engine Cooling/Radiator 20 5. Check the fan drive for fluid leakage. Very slight misting and dust accumulation around the pin in the center of the front cover is normal. Any other leakage is abnormal, and will result in poor per- formance. Replace the fan drive if there is abnor- mal leakage. 2 3 1 4 6. Move one blade tip alternately toward and away from the radiator. The allowable play is 1/16 inch (1.6 mm) at a 10-inch (254-mm) radius from the center of the fan. See Fig. 8 . If there is greater movement, and it can not be traced to loose fas- teners or fan hub pulley bearing wear, replace the fan drive.
5 6 A 05/27/93 f200237a With the fan clutch engaged, measure the distance at A; measure it again with the fan clutch disengaged. 1. Bearing Housing 2. Retaining Plate 3. Fan Pulley 4. Air Inlet (from the solenoid valve) 5. Air Cylinder 6. Fan Fig. 7, Kysor/Dynair and Kysor K22RA Fan Clutch Lining Wear Checking Schwitzer Viscous Fan Drive NOTE: After performing the checks below, if any part of the fan drive requires service or replace- ment, see Group 20 of the Heavy-Duty Trucks Service Manual for instructions. f200238 05/27/93 A = 10" (254 mm) B = 1/16" (1.6 mm) maximum play 1. Check the tightness of the fasteners attaching the fan to the fan drive, and fan drive to the fan hub.
For torque values, see Group 00 of this manual. Fig. 8, Checking Schwitzer Viscous Fan Drive Wear NOTE: When making this check, use only enough force to take up the play in the clutch without bending the blade. 2. Check the fan and surrounding area for signs of physical contact between the fan and other parts. If there has been contact, correct the cause. Re- place all damaged parts. Horton DriveMaster ® Fan Clutch 3. Check the drive belts for fraying, cracking, and correct tension; see Group 01 of the Heavy-Duty Trucks Service Manual. NOTE: If any part of the fan clutch needs to be repaired or replaced after performing the checks below, see Group 20 of the Heavy-Duty Trucks Service Manual.
4. Turn the fan by hand at least one full turn. It should turn smoothly, with some resistance. If there is binding or jerkiness, or if the fan spins freely, replace the fan drive. Heavy-Duty Trucks Maintenance Manual, January 2007 20/9 A B