Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Engine Cooling/Radiator 20 f500006a 05/27/93 1. Capscrew 2. Mounting Bracket 3. Hexnut 4. Washer 5. Drive Sleeve 6. Friction Disc 7. Capscrew 8. Panhead Screw 9. Retaining Washer 10. Rotary Air Union 11. O-Ring Seal 12. Setscrew 13. Air Chamber Assembly 14. O-Ring Seal 15. Piston Assembly 16. Friction Facing 17. Capscrew 18. Washer 19. Compression Spring Fig. 6, Horton HT 550 Fan Clutch Components inches (3.8 mm) for the Kysor K22RA, the clutch lining is worn and must be replaced. See Group 20 of the Heavy-Duty Trucks Service Manual for overhaul instructions. Model Numbers * Retaining Plate Fasteners * Kysor/Dynair Fan Clutch Wear Limits Wear Limit: in (mm) 6.

Release the air pressure, then disconnect the shop hose from the air inlet of the air cylinder. Connect the vehicle air hose to the inlet. 1090–05261–01 1090–05262–01 1090–05261–02 1090–05262–02 Bolt, Lockwasher, and Nut 0.16 (4.1) 7. Connect the electrical cables to the battery. If equipped with an air starter, charge the air starter reservoir. 1090–06620–01 1090–06060–01 1090–07050–01 1090–08000–01 1090–06620–02 1090–06060–02 1090–07050–02 Capscrew and Lockwasher 0.17 (4.3) 8. Start the engine. The LOW WTR light and warn- ing buzzer should be off. If the light and buzzer are off, the sensor is okay. If the light and buzzer are on, replace the sensor.

* The fan clutch model number is stamped on the tag on the air cylinder. Also, the models can be identified by the type of retaining plate fasteners used. Table 6, Kysor/Dynair Fan Clutch Wear Limits Heavy-Duty Trucks Maintenance Manual, January 2007 20/8