Engine Cooling/Radiator 20 6 7 8 5 19 20 18 3 4 17 21 23 22 1 2 14 15 13 11 12 16 9 10 24 03/30/95 f200194a 1. Mounting Bracket 2. Rear Sheave Bearing 3. Inner and Outer Bearing Spacers 4. Forward Sheave Bearing 5. Sheave 6. Friction Facing 7. Journal Spacer 8. Socket-Head Capscrew 9. Rear Hub Bearing 10. Bearing Spacer 11. Splined Hub 12. Forward Hub Bearing 13. Piston Friction Disc 14. Large O-Ring 15. Locknut 16. Cartridge Assembly 17. Face Seal 18. Small O-Ring 19. Air Chamber 20. Socket-Head Capscrew 21. Stud Bolt 22. Lockwasher 23. Hexnut 24. Piston Assembly Kysor/Dynair ® and Kysor K22RA Fan Clutch Fig.
5, Horton Type S and HT/S Fan Clutch Components equipped with an air starter, be sure that the air starter reservoir is drained. 2. Measure the distance from the back surface of the fan clutch retaining plate to the forwardmost edge of the fan belt pulley. See Fig. 7 , Ref. A. NOTE: Check the lining wear at the first M3 maintenance interval; the lining wear does not require checking at the first M2 interval. Subse- quent checks must be made at each M2 mainte- nance interval. 3. Disconnect the line from the air inlet of the air cylinder. Connect a shop air hose to the inlet. 4.
Apply a minimum of 100 psi (690 kPa) air pres- sure to the air cylinder—the bearing housing will move backwards, disengaging the clutch. Again, measure the distance from the back surface of the retaining plate to the forwardmost edge of the fan belt pulley. 1. Disconnect the electrical cables from the battery. Drain all air from the air system. If equipped with an air starter, drain the air starter reservoir. WARNING If the engine starts during this procedure, the fan could cause personal injury. If the vehicle is 5.
Compare the two measurements; if the difference exceeds the wear limit given in Table 6 for the Kysor/Dynair, or exceeds the wear limit of 0.15 Heavy-Duty Trucks Maintenance Manual, January 2007 20/7