Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Engine Cooling/Radiator 20 3. Check all air connections for air leaks. 5. If equipped with a toggle switch on the dash, run the engine with the engine temperature below 205°F (96°C) for Caterpillar engines, or below 200°F (93°C) for all other engines. Set the toggle switch to the ON position; the fan clutch should engage. Set the toggle switch to the AUTO or OFF position; the air should exhaust and the fan clutch should disengage. Replace the switch if necessary. 4. Check for wear on the friction facing. See Fig. 3 (Type S and HT/S) or Fig. 4 (HT 550).

Replace the facing if it is worn to 1/16-inch (1.6-mm) thickness or less on a Type S or HT/S fan clutch, or to 7/32-inch (5.6-mm) on an HT 550 fan clutch. 3 4 6. With the engine off and the fan clutch engaged, use a listening device to check for air leaks. If a leak is heard, check for air leaks in the fan clutch by lightly brushing a soap solution in the follow- ing areas: 2 5 6.1 Type S and HT/S Fan Clutches ( Fig. 3 ) 1 Check for air leaks at the bleed hole on the fan pilot. Air leakage means that the cartridge assembly ( Fig. 5 , Ref. 16) or face seal (Ref. 17) is damaged. 08/08/94 1. System Sentry ® Fuse 2. Safeguard Hole 3. Friction Facing 4. Piston Friction Disc 5.

Air Chamber f200290 Check for air leaks between the air cham- ber and the piston friction disc. Air leak- age means that the large O-ring (Ref. 14) is damaged. Fig. 3, Horton Type S and HT/S Fan Clutch Check for air leaks around the safeguard hole on the piston friction disc. Air leak- age means the small O-ring (Ref. 18) is damaged. 3 Check for air leaking from the System Sentry ® fuse. Leaking air means the clutch has gotten so hot the lead alloy in the fuse melted. This released the clutch before the heat could damage the clutch bearings. Before replacing the fuse, find and repair the source of the heat. 2 4 1 5 6.2 HT 550 Fan Clutch ( Fig. 4 ) Check the rotary air union for air leaks.

Make sure the air line at the air union is not restricted due to kinking or bending. If air leakage is found, replace the rotary air union ( Fig. 6 , Ref. 10). 10/19/93 f500005a Check for air leaks around the piston (Ref. 15) and air chamber (Ref. 13). If air leakage is found, replace the O-ring seal (Ref. 11). 1. O-Ring Seal 2. Friction Facing 3. Piston 4. Air Chamber 5. Rotary Air Union Fig. 4, Horton HT 550 Fan Clutch Heavy-Duty Trucks Maintenance Manual, January 2007 20/6