Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Clutch 25 25–01 Clutch Release Bearing Lubricating outside the bell housing, lubricate the bearing with the engine running. Using a pressure gun and high-temperature grease only, lubricate the release bearing at the grease fit- ting until grease starts coming out of the fitting. Do not use chassis lube or multipurpose lubricants. NOTE: For a clutch with a sealed release bear- ing, the release bearing is lubricated at the time of manufacture and requires no additional grease for the life of the bearing. This type of release bearing is not equipped with a grease fitting. 25–02 Clutch Release Cross- Shaft Lubricating For a clutch with a grease-type release bearing (see Fig.

1 ), wipe the dirt from the grease fitting. The clutch release cross-shaft is equipped with two grease fittings in the transmission clutch housing. See Fig. 2 and Fig. 3 . Wipe the dirt from the grease fittings. Using a pressure gun, lubricate the clutch release cross-shaft with multipurpose chassis grease. CAUTION Do not over-lubricate the clutch release bearing. Over-lubrication could contaminate the clutch in- ternally, causing clutch slippage and premature failure. Do not use chassis grease or multipurpose lubricants. 1 2 10/19/93 f250048a 1. Clutch Release Cross- Shaft 2. Grease Fitting Fig.

2, Cross-Shaft Grease Fitting, Left-Side 25–03 Clutch Linkage Components Lubricating f250081a 05/27/93 FLA/FLB Clutch Linkage Fig. 1, Release Bearing Grease Fitting IMPORTANT: If the release bearing is not equipped with a grease-fitting extension that extends outside the bell housing, lubricate the bearing with the engine stopped. If equipped with a grease-fitting extension that does extend For earlier FLAs, the clutch linkage is equipped with four grease fittings, one at each rod end spherical bearing. See Fig. 4 , Fig. 5 , and Fig. 6 . Wipe the dirt from the grease fittings. Using a pressure gun, lubri- cate the clutch linkage with multipurpose chassis grease.

Heavy-Duty Trucks Maintenance Manual, January 1998 25/1