Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Clutch 25 f260146a 05/27/93 05/27/93 f250176a Fig. 3, Cross-Shaft Grease Fitting, Right-Side Fig. 5, Earlier FLA Clutch Intermediate Bellcrank Grease Fittings 1 05/27/93 f250175a Fig. 4, Earlier FLA Clutch Pedal Lever Grease Fitting 2 3 Later FLAs and all FLBs are equipped with a grease fitting on the inboard side of the bellcrank pivot pin. See Fig. 7 . Wipe the dirt from the fitting. Using a pressure gun, lubricate the pivot pin with multipur- pose chassis grease. 05/27/93 f250045a 1. Left-Hand Frame Rail 2. Grease Fitting 3. Clutch Release Lever Fig. 6, Earlier FLA Clutch Release Lever Grease Fitting Some FLAs are equipped with a grease fitting on the clutch pedal shaft.

Wipe the dirt from the fitting. Using a pressure gun, lubricate the clutch pedal shaft with multipurpose chassis grease. FLB Right-Hand Drive bearings. Using a pressure gun, lubricate each bear- ing with multipurpose chassis grease. See Fig. 8 . Locate the grease fitting on the side of the steering column bracket at the end of the crossover shaft lube tube. Using a pressure gun, lubricate the tube with multipurpose chassis grease. See Fig. 9 . On right-hand drive FLBs, there are three additional lubrication points on the clutch linkage crossover shaft.

FLD Clutch Linkage Remove the plastic cap from the grease fitting on both the left-hand and right-hand crossover shaft The FLD clutch linkage is equipped with two grease fittings. See Fig. 10 and Fig. 11 . Heavy-Duty Trucks Maintenance Manual, January 1998 25/2