Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Transmission 26 26–01 Shift Control Telescoping Tubes Lubricating and Inspecting, FLA/FLB 5. Return the cab to the upright and locked position using the instructions in Group 00 of this manual. 6. Remove the chocks from the tires. 26–03 Shift Lever Pivot Yokes Inspecting, FLA/FLB 1. Apply the parking brakes, and chock the tires. 2. Tilt the cab to the full-tilt position, using the in- structions in Group 00 of this manual. 1. Remove the tunnel top cover. 3. Wipe off the telescoping tubes ( Fig. 1 ) with a clean cloth. 2. Remove the screws that attach the center con- sole tray. 4. Inspect the tubes for wear or damage. If worn or damaged, replace them with new ones.

See Group 26 of the Heavy-Duty Trucks Service Manual for procedures. 3. Remove the lower cover from the shift knob, then disconnect the air lines from the shift knob. 4. Loosen the locknut and remove the shift knob. 5. Inspect the O-ring located near the top of the telescoping tubes. See Fig. 2 . If worn or dam- aged, install a new O-ring. See Group 26 of the Heavy-Duty Trucks Service Manual for proce- dures. 5. Remove the screws that attach the shift boot to the tunnel, then remove the shift boot. 6. Using a 0.062-inch (1.6-mm) feeler gauge, check the clearance between the pivot block yoke and pivot block. Also, check the clearance between the shift lever yoke and the shift lever. See Fig.

4 . 6. Apply a light coating of multipurpose chassis grease on the surfaces of the telescoping tubes. 7. Return the cab to the upright and locked position using the instructions in Group 00 of this manual. If the shift lever yoke clearance is more than 0.062 inch (1.6 mm), and the nylon washer is not worn out, tighten the yoke nut 100 lbf·in (1130 N·cm) then back it off 1/4 turn. If the nylon washer is worn, remove the shift lever assembly, and replace the worn parts. See Group 26 of the Heavy-Duty Trucks Service Manual for proce- dures. 8. Remove the chocks from the tires.

26–02 Shift Control Latch Lubricating and Cylinder Inspecting, FLA/FLB If the pivot block yoke clearance is more than 0.062 inch (1.6 mm), remove the shift lever as- sembly, and replace the worn parts. See Group 26 of the Heavy-Duty Trucks Service Manual for procedures. 1. Apply the parking brakes, and chock the tires. 2. Tilt the cab using the instructions in Group 00 of this manual. 3. Check the latch cylinder for signs of leakage. See Fig. 2 . If leaking, replace it with a new one. See Group 26 of the Heavy-Duty Trucks Service Manual for procedures. 26–04 Selection Lever and Pivot Rod Ball Stud Lubricating, FLA/FLB 4.

Inspect the latch arm and locking tab areas on the shift control tube assembly for wear. See Fig. 3 . Replace any worn parts. See Group 26 of the Heavy-Duty Trucks Service Manual for procedures. Lubricate the latch arm, locking tab, and latch guide with a light coating of chassis grease. Wipe off the selection lever and pivot rod ball stud grease fittings. See Fig. 5 . Apply multipurpose chas- sis grease with a pressure gun at each fitting until new grease appears at the seals. Heavy-Duty Trucks Maintenance Manual, November 2001 26/1