Transmission 26 Fig. 1, Telescoping Tubes of the FLA/FLB Tunnel-Mounted Shifter 26–05 Allison Transmission Fluid and Filter Changing 1. Park the vehicle on a level surface. Apply the parking brakes, and chock the tires. 2. Operate the vehicle until the transmission reaches normal operating temperature: 160 to 200°F (71 to 93°C). When draining transmission fluid, check for evidence of dirt or water contamination. A small amount of condensation will appear in the fluid during operation. 3. Clean the area around the drain plug and the transmission fluid pan. Place a drain pan under the transmission and remove the drain plug. Ex- amine the fluid as it drains.
If only the filter is being changed, do not drain the fluid. Water contamination is normally characterized as a milky discoloration of the transmission fluid. Obvious contamination of the transmission fluid indicates a leak between the water and fluid areas of the trans- mission cooler. Inspect and pressure-test the cooler to confirm the leak; replace leaking transmission coolers. 4. Remove the 12 mounting bolts (six each) from the two filter covers. 5. Remove the filter covers, O-rings, and two square-cut seals from the transmission. See Fig. 6 . Heavy-Duty Trucks Maintenance Manual, November 2001 26/2 27/93 f260