Transmission 26 1 1 B A 2 f260004a 05/27/93 A. Check shift lever yoke clearance here. B. Check pivot block yoke clearance here. 1. Shift Lever Yoke Nut f260145a 05/27/93 1. Latch Cylinder 2. O-Ring Fig. 2, Shift Control Latch Cylinder Fig. 4, Shift Lever and Pivot Block Yokes 2 1 2 05/27/93 f260003a 1. Latch Arm 2. Latch Cylinder Pivot Pin 1 2 Fig. 3, Shift Control Latch Arm and Locking Tab 05/27/93 1. Selection Lever Ball Stud Grease Fitting 2. Pivot Rod Ball Stud Grease Fitting f260005a 6. Remove the filters from the bottom of the control module. 7. Lubricate the new O-rings with transmission fluid, and install them on the cover assemblies. Fig.
5, Selection Lever and Pivot Rod Ball Studs 10. Align each cover assembly with the holes in the channel plate sump, and push the cover assem- blies in by hand to seat the seals. 8. Install a new square-cut seal on each cover as- sembly, and install the fluid filter elements on the cover assemblies. CAUTION 9. Install the filter and cover assemblies into the filter compartment. Do not use the bolts to draw the filter covers to the sump. This can damage the covers, seals, or sump. Heavy-Duty Trucks Maintenance Manual, November 2001 26/3