Transmission 26 Fuller Transmission Oil Filter Element Changing 1. After draining the transmission case, remove the attaching bolts and filter cover from either one or both power take-off openings in the case. 2. Remove and discard the filter element(s). 3. Install the new filter element in the power take-off opening in the case. 4. Attach the cover to the case with the attaching bolts. See Group 00 in this manual for torque values. 5. Fill the transmission with recommended clean oil, as instructed under "Manual Transmission Oil Changing." 26–07 Transmission Air Filter/ Regulator Checking, and Cleaning or Replacing f260037a 05/27/93 Fuller Transmission Fig.
9, Air Filter/ Regulator Location (Fuller transmission shown) 2 3 4 5 6 7 WARNING Drain the air supply; if the air supply is not drained before the air filter/regulator is serviced, serious injury and component damage could re- sult. 1. Apply the parking brakes and chock the tires. Drain the air from the air reservoirs. 1 2. Clean the outside of the air filter/regulator with cleaning solvent, then let it air dry. See Fig. 9 . f260052a 10/17/2001 3. Remove the end cap, large O-ring, and filter ele- ment from the filter housing. See Fig. 10 . Re- move the small O-ring from the end cap. NOTE: Do not remove, disassemble, or adjust the air regulator.
If the air regulator is not keep- ing the air pressure between 58 and 63 psi (400 and 434 kPa), replace the air filter/regulator, which is not serviceable. WARNING 1. Air Regulator 2. Housing 3. Large O-Ring 4. Filter Element 5. Small O-Ring 6. End Cap 7. Plug Fig. 10, Eaton Fuller Transmission Air Filter/Regulator Components Wear eye protection when using compressed air to clean parts, as permanent harm to eyes could result from flying debris. Heavy-Duty Trucks Maintenance Manual, November 2001 26/8