Transmission 26 4. Clean the filter element by dipping it in alcohol or other cleaning solvent. Blow compressed air through the filter element (inside to outside) to loosen surface dirt and to dry the element. If it is not damaged, the sintered metallic filter element will last the life of the vehicle. 1 2 3 4 5 6 7 8 9 Wipe out the filter housing with a clean, dry, lint- free rag. Clean and inspect the O-rings and the end cap. Replace any parts that are damaged. 5. Install the large O-ring, then the filter element (small end first) into the filter housing. f260053a 05/27/93 1. Regulator 2. Louver 3. Upper Gasket 4. Element 5. Lower Gasket 6. Stud 7. O-Ring 8. Bowl 9. Drain Valve 6.
Install the small O-ring in the end cap, then in- stall the end cap and tighten it 8 to 12 lbf·ft (11 to 16 N·m). Fig. 11, Spicer Transmission Air Filter/Regulator Components 7. Start the engine, and build pressure in the air system. Check for air leaks at the filter housing and air line connections; repair any leaks. 5. Clean and inspect all parts. Use only a petroleum-based solvent to clean the parts. Blow air through the filter element (inside to outside) to loosen surface dirt. CAUTION A leaking air filter or air lines can cause slow or hard shifting of the transmission, and eventual transmission damage. Spicer Transmission IMPORTANT:
After three cleanings, replace the filter element with a new one. Do not disassemble the regulator, as it is not repairable. If the air regulator does not work properly, replace the unit. WARNING 6. Install the lower gasket, the cleaned or new ele- ment, the upper gasket, and the louver, on the stud. Install the element so the large end of the internal taper (thinnest wall section) is toward the hex on the stud. Drain the air supply; if the air supply is not drained before the air filter/regulator is serviced, serious injury and component damage could re- sult. 1. Apply the parking brakes, and chock the tires. Drain the air from the air reservoirs. 7.
Install and tighten the stud 5 to 10 lbf·in (60 to 100 N·cm). 2. Clean the outside of the air filter/regulator ( Fig. 11 ) with cleaning solvent, then let it air dry. 8. Apply a light coat of Dow Corning DC7 silicone grease, or an equivalent, to the O-ring seating surfaces on the regulator and the bowl. 3. Loosen or remove the air filter/regulator bracket clamp, then unscrew the bowl; hold the regulator to prevent it from turning. Remove the O-ring. 9. Apply a light, even coat of Molykote "G," or an equivalent, to the bowl threads. Install and tighten the bowl 5 to 10 lbf·in (60 to 100 N·cm). 4. Unscrew the stud from the regulator.
Remove the louver, upper gasket, element, and lower gasket from the stud. 10. Install and/or tighten the air filter/regulator bracket clamp. 11. Install and torque the drain valve, if removed, 10 to 15 lbf·in (120 to 160 N·cm). WARNING 12. Build air pressure in the system, check for leaks, and make any necessary repairs. Wear eye protection when using compressed air to clean parts, as permanent harm to eyes could result from flying debris. Heavy-Duty Trucks Maintenance Manual, November 2001 26/9