Transmission 26 Meritor Transmission If the breather is plugged, clean or replace it. See Fig. 7 . Check more often if the vehicle operates under very dusty conditions. WARNING Drain the air supply; if the air supply is not drained before the air filter/regulator is serviced, serious injury and component damage could re- sult. Allison Transmission CAUTION 1. Apply the parking brakes and chock the tires. Drain the air from the air reservoirs. Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Do not mix types and brands of fluid, because of possible incompatibility.
Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. Cold Check 2. Clean the outside of the air filter/regulator with cleaning solvent, then let it air dry. 3. Remove the end cap from the air filter/regulator assembly, then inspect the O-rings in the end cap. Replace worn or damaged O-rings. 4. Remove the element from the filter/regulator as- sembly. Clean all dirt from around the end of the fluid fill tube before removing the dipstick. Do not allow foreign matter to enter the transmission. Dirt or foreign mat- ter in the hydraulic system may cause undue wear of transmission parts, make valves stick, and clog pas- sages. 5.
Inspect the element for oil. If oil is in the ele- ment, replace the element. Inspect the air supply system for the source of oil, and service it as needed. 6. Install the element in the filter/regulator assem- bly. It is important to check the fluid level while cold to determine if the transmission has a sufficient amount of fluid to be safely operated until a hot check can be performed. 7. Apply a light coat of Dow Corning DC7 silicone grease, or an equivalent, to the O-rings in the end cap. 1. Park the vehicle on a flat, level surface. 8. Install and tighten the end cap 10 to 15 lbf·ft (14 to 20 N·m). 2. Apply the parking brake and chock the tires. 9.
Build air pressure in the system, check for leaks, and make any needed repairs. 3. Run the engine for at least one minute. 4. Shift from DRIVE to NEUTRAL, and then shift to REVERSE to fill the hydraulic system. 26–08 Transmission Oil Level Checking and Breather Checking 5. Shift to NEUTRAL and allow the engine to idle at 500 to 800 rpm. 6. With the engine running at idle, remove the dip- stick from the tube and wipe it clean. NOTE: For vehicles with auxiliary transmissions, use this procedure to check the auxiliary trans- mission oil level and breather whenever check- ing the main transmission oil level and breather. 7. Insert the dipstick into the tube and remove the dipstick. 8.
Check the fluid level reading and repeat the check procedure to verify the reading. Breather Checking If the fluid level is within the COLD RUN band, the transmission may be operated until the fluid is hot enough to perform a hot check. Transmission housing breathers must remain clear. A plugged breather could result in pressure build-up, which could cause oil leakage. If the fluid level is not within the COLD RUN band, add or drain fluid as needed to adjust the Heavy-Duty Trucks Maintenance Manual, November 2001 26/10