Transmission 26 fluid level to the middle of the COLD RUN band. See Fig. 12 . Eaton/Fuller Transmission CAUTION B Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Overfilling will force fluid out of the case through the main shaft openings. Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. A 12/01/97 A. Cold Run Band B. Hot Run Band f270002a Fig.
12, Dipstick Markings With the transmission at operating temperature, and the vehicle on a level surface, check the fluid level in the transmission. CAUTION As the fluid temperature increases, so does the fluid level. Do not fill above the COLD RUN band if the transmission fluid is below normal operating temperature. 1. Clean the area around the fill plug, and remove it from the side of the case. 2. Using your finger or a bent pipe cleaner, see if the fluid is level with the fill opening. See Fig. 8 . 3. If the transmission fluid level is low, check the transmission for leaks, and correct as needed. NOTE:
Perform a hot check at the first opportu- nity after the normal operating temperature, 160 to 200°F (71 to 93°C), has been reached. 4. If needed, add the recommended fluid, until it is level with the lower edge of the fill opening. See Table 2 for approved transmission lubricants. Hot Check 1. Park the vehicle on a flat, level surface. Apply the parking brake and chock the tires. 5. Clean the fill plug, install it in the transmission, then tighten it 50 lbf·ft (68 N·m). Meritor Transmission 2. Shift the transmission to NEUTRAL. 3. Operate the engine at idle (500 to 800 rpm) until normal operating temperature is reached. Check that the sump temperature is 160 to 200°F (71 to 93°C).
Check that the converter-out temperature is 180 to 220°F (82 to 104°C). CAUTION Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. 4. With the engine idling, remove the dipstick from the tube and wipe it clean. 5. Insert the dipstick into the tube and remove the dipstick. 6. Check the fluid level reading and repeat the check procedure to verify the reading.
Safe oper- ating level is within the HOT RUN band on the dipstick. The HOT RUN band is between the HOT FULL and HOT ADD marks. 1. Remove the fill plug from the transmission. 2. Insert a finger or pipe cleaner into the transmis- sion. If the fluid level is not within the HOT RUN band, add or drain fluid as needed to bring the fluid level within the HOT RUN band. See Fig. 12 . 3. Check that the fluid level is even with the base of the fill plug. See Fig. 8 . Heavy-Duty Trucks Maintenance Manual, November 2001 26/11