Frame and Fifth Wheel 31 31–01 Fifth Wheel Inspecting 8.2 Release the lock by tripping the release latch at the bottom of the throat. WARNING 8.3 Adjust the wedge stop at the end of the wedge to approximately 1/4-inch (6-mm) clearance by turning the wedge stop rod located on the right side of the top plate. All fifth wheel maintenance, adjustment, and re- building must be done only by a qualified me- chanic. Improper or incomplete procedures could result in a possible disengagement of the trailer from the tractor, which could result in personal injury or property damage. 9. Replace cracked, worn, or damaged parts with new parts.
Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. Parts are under spring compression. Wear safety goggles while servicing the fifth wheel. Failure to do so can result in personal injury, due to parts ejecting with force. Fontaine 10. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. Apply a generous coating of grease to the top plate to fill the grooves, or depressions, on the top plate. See Maintenance Operation 31–02 for lubrication instructions. Holland 1. Disconnect the tractor from the trailer.
For in- structions, see the vehicle driver’s manual. 2. Thoroughly steam clean the fifth wheel. 3. Look for cracks in the fifth wheel assembly, mounting brackets, and mounting parts. 1. Disconnect the tractor from the trailer. For in- structions, see the vehicle driver’s manual. 4. Check the jaw and stationary jaw for mushroom- ing, and check that the serrations at the jaw and wedge are in good condition. 2. Thoroughly steam clean the fifth wheel. 3. Check for loose nuts or broken bolts on the fifth wheel assembly. 5. Test the safety lock latch for ease of operation. NOTE: The safety lock latch is located at the front of the fifth wheel on the top plate. 4.
Inspect for cracks or wear on the mounting bolts. 5. Visually inspect for improper locking action and for cracks or wear on the jaw locking mecha- nism. 6. Visually check for loose nuts or bolts (see Fig. 1 ) on the fifth wheel and on the mounting. Set a torque wrench to the maximum torque value for the bolt being checked, and confirm that the torque is to specification. Do not loosen the bolt to check the torque value. See Group 00 of this manual for bolt torque specifications. 6. Check the depth of the grease grooves. If the depth of the grooves is 1/8 inch or less, replace the fifth wheel top plate. See Group 31 of the Heavy-Duty Trucks Service Manual. 7.
Check the condition of the X-pattern cast into the underside of the fifth wheel top plate. See Fig. 2 . The fifth wheel top plate must be removed to check the X-pattern. 7. Visually check all springs to see if they are se- curely fastened, and are not deformed. WARNING 7.1 Remove the roll pins from the bushing pins. Remove the bushing pins from the slide mount. Using a hoist, lift the fifth wheel top plate off of the vehicle. Do not disassemble the fifth wheel to inspect the springs. The springs are under extreme pressure, and could cause serious injury. 7.2 Turn the fifth wheel top plate over with the locks open. Check the condition of the X-pattern in the pockets.
If the X-pattern is worn away, replace the fifth wheel top plate. 8. Check wedge adjustment. 8.1 Open the kingpin lock, and vertically in- sert a two-inch-diameter shaft. Heavy-Duty Trucks Maintenance Manual, October 2009 31/1