Frame and Fifth Wheel 31 13 14 10 15 11 12 3 1 2 14 16 9 4 17 18 1 19 1 21 2 3 4 20 22 21 23 25 5 6 7 6 8 21 23 24 26 f310476 09/18/95 1 1. 3/16 x 1 Cotter Pin 2. Lower Bracket Retainer Pin 3. Grease Fitting 4. Lower Bracket Pin 5. Wedge Stop Rod 6. Flatwasher 7. Wedge Stop Rod Spring 8. Wedge Stop Rod Nut 9. Side Release Upper Assembly 10. Leaf Spring 11. 1/4–20 x 3/8 Thread-Cutting Screw 12. Step Jaw and Wedge 13. Jaw Spring 14. 1/4 x 3 Cotter Pin 15. Timer 16. Wedge Spring 17. Pull Handle 18. Bumper Handle Spring 19. 1/2–13 x 2 Bumper Pivot Bolt 20. Bumper 21. Flatwasher 22. 5/16" Bumper Pivot Bushing 23. 1/2–13 Locknut 24. 7/16" Handle Pivot Bushing 25.
Operating Handle (side-release only) 26. 1/2–13 x 2 Handle Pivot Bolt Fig. 1, Fontaine H5092 Series Fifth Wheel (left-side-release shown) 7.3 Install the fifth wheel top plate, bushing pins, and roll pins. Castloc II and Simplex Series 1. Disconnect the tractor from the trailer. For in- structions, see the vehicle driver’s manual. 8. Inspect for fatigue or cracked welds. 9. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. 2. Thoroughly steam clean the fifth wheel. 3. Check the fifth wheel plate for cracks.
Check for sharp edges on top; the chamfer should be 1/8 to 1/4 inch (3 to 6 mm). 10. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. See Maintenance Operation 31–02 for lubrica- tion instructions. 4. When the wheel is locked, the safety latch must swing free and fall freely into position. See Fig. 3 . Heavy-Duty Trucks Maintenance Manual, October 2009 31/2