Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Frame and Fifth Wheel 31 31–04 Holland Fifth Wheel Sliding Mechanism Inspecting NOTE: The use of soap is not recommended for cleaning the electrical connector, as some soaps may increase the corrosion process. 1. Wash out any existing grease, dirt, and corrosion on the trailer connectors with electrical contact cleaner spray. 1. Loosen the locking plunger jam nut and turn the adjusting bolt out (counterclockwise). See Fig. 9 . 2. Grease the trailer connector with a lithium-based dielectric grease. 2 3 4 1 11/21/95 f310371 1. Rack 2. Plunger 3. Pocket 4. Plunger Adjusting Bolt Fig. 9, Locking Plungers 2. Disengage and engage the locking plungers.

Check that the plungers are securely seated without binding. If the locking plungers do not operate properly, see Group 31 of the Heavy- Duty Trucks Service Manual for adjustment pro- cedures. 3. Turn the adjusting bolt in (clockwise) until it con- tacts the rack. Turn the adjusting bolt an addi- tional 1/2 turn, then securely tighten the locking nut. 31–05 Trailer Electrical Connector Lubricating In some cases, failure of trailer cables occurs due to intrusion of chloride-based road deicing chemicals into the trailer connector. Once inside the connector, the chloride-based chemicals corrode the brass ter- minals and create bridging between positive and ground terminals.

Heavy-Duty Trucks Maintenance Manual, October 2009 31/8