Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Frame and Fifth Wheel 31 grease. Using a pry tool, separate the jaw and wedge and lubricate the serrations using a brush to distribute the grease. On slide-mount applications, lubricate the slide rail and tapered wedges for smooth operation. the torque of frame fasteners, inspect the frame for cracks and other damage. Set a click-type torque wrench to the maximum torque of the fastener you are checking. Apply pressure until the torque wrench clicks. Do not loosen the bolt to check the torque. See the applicable torque table in Group 00 for torque specifications.

Once the moving parts of the fifth wheel are lubri- cated, apply a liberal coating of grease to the top plate and the trailer kingpin plate. Holland CAUTION Make sure frame fasteners are properly tightened. Continued vehicle operation with loose fasteners could result in bracket or frame damage. Lubricate all moving parts with a multipurpose chas- sis grease. Lubricate, with a multipurpose chassis grease, the two grease fittings located on either side of the top plate. NOTE: Engine supports on vehicles built from January 2007 do not require checking. Once the fifth wheel’s moving parts are lubricated, apply a heavy coat of grease to the top plate by di- rect application.

On slide-mount applications, lubri- cate the baseplate rails and the plungers for smooth operation. Castloc II and Simplex Series Inspect, and check the torque of the fasteners at these locations: Axle Stops Deck Plates Engine Trunnion Supports Use a chassis or multipurpose grease to lubricate the two grease fittings located on either side of the fifth wheel top plate. Lubricate the two grease fittings lo- cated in the grease grooves on the fifth wheel top plate. Lubricate the two grease fittings located below the top plate mounting pins. Lubricate the lock mechanism.

Equalizer Brackets Exhaust Brackets Fifth Wheel Legs Fifth Wheel Mountings Frame Crossmembers and Gussets Once the fifth wheel’s moving parts are lubricated, apply a heavy coat of grease to the top plate, either through the grease fittings located on the underside of the top plate, or by direct application. On slide- mount applications, lubricate the slider lock pockets and the slider bracket.

Front Frame Brackets Front Suspension Spring Brackets Fuel Tank Brackets Radius Rods Rear Engine Supports 31–03 Frame Fastener Torque Checking Rear Suspension Spring Brackets Shock Absorbers All Other Frame Fasteners Frame brackets and components secured with Huck- bolt ® fasteners do not require a torque check, how- ever, they should be inspected for damage. Frame brackets and components secured with conventional bolts and nuts are to be checked at initial mainte- nance (IM). Check the torque of frame fasteners to offset the effects of "bedding in" (or seating). When checking torque, torque the nut, not the bolt head whenever possible.

This will give a true torque read- ing by eliminating bolt body friction. When checking Any component that shows signs of cracking or other damage, must be repaired or replaced. Refer to the Heavy-Duty Trucks Service Manual for repair or re- placement information in the respective section for the component in question. Heavy-Duty Trucks Maintenance Manual, October 2009 31/7