Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Suspension 32 following the procedures in Group 32 of the Heavy-Duty Trucks Service Manual. 6. Inspect all suspension fasteners for proper torque values. See Group 00 of this manual for proper bolt torque specifications. Chalmers Walking Beam Suspension, 800 Series 16. Inspect the shock absorbers for oil leaks and worn rubber bushings. Replace the shock ab- sorbers and/or rubber bushings if wear or dam- age is noted. For instructions, see Group 32 of the Heavy-Duty Trucks Service Manual. 17. Remove the safety stands and lower the rear of the vehicle to the ground. Run the engine until air pressure of at least 100 psi (689 kPa) is maintained throughout the system.

Chock the front tires to prevent the vehicle from mov- ing. Place the transmission in neutral, and release the parking brakes before inspecting the Chalmers rear suspension. Power wash the Chalmers rear suspension, or clean it with a hard-bristle brush before performing a visual inspection. 18. Check that all air springs are inflated. If the air springs do not inflate, see Group 32 of the Heavy-Duty Trucks Service Manual for possible causes and corrections. 1. Visually inspect the rubber bushings for cracks or other damage. 19. Apply the parking brakes and remove the chocks. Reyco 79KB and 179 Try to move the torque rod ends using your hands only, and check for any free-play.

If free- play is felt, replace the torque rod end bushing. Do not use a pry bar to check for free-play. Use of a pry bar may lead to premature bushing re- placement. Park the vehicle on level ground and chock the front tires to prevent the vehicle from moving. Place the transmission in neutral, and release the parking brakes. 2. Lift the rear of the vehicle and support the frame on jack stands to unload the suspension compo- nents. The vehicle is lifted high enough when the beam ends are off of the saddles. All jack stands must be of sufficient strength and rigidity to safely support the vehicle. Do not perform any work on or around a vehicle that is supported solely by a lifting device. 1.

Check that the torque rod clamps are directed away from the spring to prevent possible interfer- ence during operation. See Fig. 11 for a Reyco 79KB, or Fig. 12 for a Reyco 179. 2. Check the fit of springs to hangers to ensure good ride characteristics. 3. Check for elongated holes in the suspension components. See Group 32 of the Heavy-Duty Trucks Service Manual for proper repair proce- dures. Visually inspect the walking beam for cracks or other damage. If damage is found, replace the walking beam. Keep the vehicle supported by the jack stands for the next operation. 4. Check bushing condition. Replace any bushing that is worn, cracked, dry-rotted, or otherwise damaged.

See Group 32 of the Heavy-Duty Trucks Service Manual for bushing removal and installation instructions. 3. Manipulate the walking beam so that a microme- ter, vernier, or dial caliper may be used to deter- mine the wear area thickness on the bottom face. See Fig. 13 . Measurements should be taken a minimum of 1/2 inch from the beam flange edges to eliminate any edge wear that may have occurred. Subtract the wear area thickness ( Fig. 13 , Ref. B) from the thickness at the non-wear area ( Fig. 13 , Ref. A) to determine the amount of wear. 5. Check tire condition. If abnormal wear is found, check and replace all worn or damaged compo- nents, and check suspension alignment.

See Group 32 of the Heavy-Duty Trucks Service Manual for component removal and installation procedures, and for suspension alignment in- structions. If the beams show any wear greater than 0.062 inch (1.5 mm), a Chalmers wear plate must be installed, or the walking beam must be replaced. Heavy-Duty Trucks Maintenance Manual, October 2009 32/6