Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Suspension 32 A 1 4 1 3 2 A 5 05/15/95 f320410 A. Measure the length of the overtravel lever between these two points. 1. V-Shaped Mark 2. Adjustment Locknut 3. Overtravel Lever 4. Cotter Pin 5. Linkage Rod Fig. 9, AirLiner Overtravel Lever and Linkage Rod Measurement 5. On single-drive rear axle configurations, measure the distance from the bottom of the left axle stop to the top of the U-bolt pad. On tandem (dual- drive) rear axle configurations, measure the dis- tance from the bottom of the forwardmost left axle stop to the top of the axle U-bolt pad. See Fig. 10 , Ref. A. The correct distance for single and dual-drive rear axles is between 2-3/8 inches and 2-7/8 inches (60 to 73 mm).

08/16/96 f320453 A. Measure height here. 1. Left Forwardmost Axle Stop Fig. 10, AirLiner Axle Stop Measurement 11. Raise the rear of the vehicle so the tires just clear the ground and the suspension is fully ex- tended. Place safety stands under the vehicle frame. 6. If the axle stop measurement is not correct, see Group 32 of the Heavy-Duty Trucks Service Manual for adjustment procedures. 7. Without detaching the control rods, attempt to move (by hand) each control-rod end up, down, in, and out. If there is any movement, examine the control rod for wear or damage. If a control rod needs to be replaced, see Group 32 of the Heavy-Duty Trucks Service Manual for instruc- tions. 12.

Squeeze all air springs to check for complete deflation. If any air springs remain partially or fully inflated, see "Troubleshooting" in the appro- priate section in Group 32 of the Heavy-Duty Trucks Service Manual. 13. Inspect each air spring for wear at its connection to its pedestal. Replace any worn air springs; for instructions, see Group 32 of the Heavy-Duty Trucks Service Manual. 8. Inspect the rubber bushings for cracks or cuts. 9. Check for any shifting of the barpin. 10. Inspect the weld seams between the control rod tube and the shorter bushing tubes. If there are cracks, replace the control rod. Do not weld the control rod for any reason. 14.

Check the axle connection welds (beam-seat to equalizing-beam and axle-adapter to axle) for cracks. If welds are cracked, grind them out and reweld the parts. 15. Move the axle up and down while checking for signs of looseness due to worn parts at the front pivot connections. Replace any worn parts by Heavy-Duty Trucks Maintenance Manual, October 2009 32/5