Suspension 32 3 bolts 45 lbf·in (500 N·cm). Any damage to the valve housing will void the warranty. 1 Do not attempt to disassemble the Barksdale valve body or the control lever. There are no serviceable parts in the valve, and any disas- sembly will void the warranty. NOTICE When removing or loosening a Barksdale height- control valve from a mounting bracket, always hold the valve-side mounting studs in place with an Allen wrench while loosening or tightening the nuts that attach the valve to the bracket. Because the mounting studs are threaded into the valve body, loosening the nuts without holding the studs can tighten the studs, which can crush the valve body and damage the valve.
Conversely, tightening the nuts without holding the studs can back the studs out, causing a separation of the two halves of the valve body, and possibly a leak. 2 f320111a 05/27/93 1. Nut 2. End Tube 3. Beam Hanger Fig. 8, Tube-Type Beam End Connection 5. Without detaching the torque arms, attempt to move (by hand) each radius-rod end up, down, in, and out. If there is any movement, replace the torque arm. If a torque arm needs to be re- placed, see Group 32 of the Heavy-Duty Trucks Service Manual for instructions. 1. Park the vehicle on a level surface, using a light application of the brakes. Do not apply the park- ing brakes.
Shift the transmission into neutral, and build the secondary air pressure to at least 100 psi (690 kPa). Shut down the engine. 6. Inspect the rubber bushing ends. Replace the torque arm for any of the following reasons: If there are gaps between the rubber bush- ing and the pin or outer steel sleeve. 2. Mark the location of the front and rear tires on the floor, and chock the tires on one axle only. If either bushing end contacts a torque arm pin mounting bolt. 3. Check that the air line support brackets are posi- tioned so the air lines do not rub against any- thing. Reposition any configurations that could contact and result in friction or wear.
There must be at least 1 inch (25 mm) clearance around the rubber air spring when inflated. If clearance is less than 1 inch (25 mm), relocate the obstruct- ing parts. If there are cracks in the bushing. If part of the rubber bushing extends be- yond the outer circumference of the outer bushing sleeve. Freightliner AirLiner Air Suspension 4. Check the length of the overtravel lever between its pivot points. See Fig. 9 , Ref. A. IMPORTANT: Before checking the AirLiner sus- pension height, make sure there is no load on the chassis, and the trailer is unhitched. 4.1 If the vehicle is equipped with an adjust- able leveling valve, the length should be 8 inches (203 mm).
If the length is incor- rect, see Group 32 of the Heavy-Duty Trucks Service Manual for adjustment procedures. IMPORTANT: To prevent voiding the warranty on Barksdale height-control valves, note the fol- lowing: Do not overtighten the bolts in the Barksdale height-control valve housing. The bolts should not be loose, and should not require tightening. Only if necessary, tighten the valve housing 4.2 If the vehicle is equipped with a fixed lev- eling valve, see Group 32 of the Heavy- Duty Trucks Service Manual for the over- travel lever length for the rear axle installed in your vehicle. Heavy-Duty Trucks Maintenance Manual, October 2009 32/4 1