Suspension 32 1 2 beam end connection), tighten the nut 210 to 240 lbf·ft (285 to 325 N·m). If equipped with the tube-type beam end connection (see Fig. 8 ), tighten the nut 375 to 425 lbf·ft (508 to 576 N·m). Do not overtorque. A 3 5 4 2 f320023a 05/27/93 5 A. 1/8" (3 mm) Clearance 1. Frame Fasteners 2. Frame Rail 3. Pry Bar 4. Equalizer 5. Equalizer Bracket 1 Fig. 4, Top View of the Equalizer 2 3 4 f320110a 05/27/93 NOTE: Do not use the three-piece adapter without the intermediate tube. 1. Nut 2. Adapter 3. Intermediate Tube 4. Inner Metal of Beam End Bushing 5. Beam Hanger Fig. 6, Three-Piece Adapter-Type Beam End Connection 4 f320039a 05/27/93 1. Beam Hanger 2. Equalizer Beam 3.
Jack 2 Fig. 5, Raising the Hendrickson Suspension Beam End WARNING Insufficient beam end fastener torque could cause the beam to separate from the axle. This will cause loss of vehicle control resulting in property damage, serious personal injury or death. 1 4. After repairs to the suspension, check the fas- tener torque after the vehicle has been in service for 2500 miles (4000 km). If equipped with the adapter-type beam end connection (see Fig. 6 for the three-piece adapter-type beam end con- nection, or Fig. 7 for the two-piece adapter-type 05/27/93 2 3 f320317a 1. Nut 2. Adapter 3. Inner Metal of Beam End Bushing 4. Beam Hanger Fig.
7, Two-Piece Adapter-Type Beam End Connection Heavy-Duty Trucks Maintenance Manual, October 2009 32/3 1 2 3