Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Suspension 32 placed, see Group 32 of the Heavy-Duty Trucks Service Manual for instructions. 4. Inspect the weld seams between the torque arm tube and the shorter bushing tubes. If there are cracks, replace the torque arm. Do not weld the torque arm for any reason. 5. Inspect the rubber bushing ends. See Fig. 2 . Re- place the torque arm for any of the following rea- sons: If there are gaps between the rubber bush- ing and the pin or outer steel sleeve. If either bushing end contacts a torque arm pin mounting bolt. f320021a 05/27/93 If there are cracks in the bushing. Fig.

2, Torque Arm Bushings If part of the rubber bushing extends be- yond the outer circumference of the outer bushing sleeve. 1 A 6. Block up the frame enough to take chassis weight off the springs. Attempt to move the equalizer up and down, using a pry bar between the top of the equalizer and top of the equalizer bracket; apply hand pressure only. See Fig. 3 . If movement at the center of the equalizer exceeds 1/8 inch (3 mm), replace the equalizer bushings. See Group 32 of the Heavy-Duty Trucks Service Manual for instructions. 3 2 7. With the vehicle unloaded, attempt to move the equalizer side to side, using a pry bar between the equalizer and frame rail. Apply hand pressure only. See Fig.

4 . If clearance between the equal- izer assembly and any frame component or fas- tener is less than 1/8 inch (3 mm), replace the equalizer bushings. See Group 32 of the Heavy- Duty Trucks Service Manual for instructions. Hendrickson Spring/Walking Beam Suspension, Models RT, RTE, and RTEA f320022a 05/27/93 A. Measure the change in gap at this point. 1. Equalizer Bracket 2. Equalizer 3. Pry Bar Fig. 3, Side View of the Equalizer 2. Check for distorted or frayed rubber at the beam end bushings. If the bushings are damaged, re- place them. 3. Check that the ends of the equalizer beam are not lower in the beam hanger.

If the equalizer beam ends appear lower, use a jack to raise each beam end, and check for movement of the inner metal of the rubber end bushing. See Fig. 5 . Movement cannot be corrected by tightening the fastener, because parts could be damaged. If there is movement, replace the rubber end bush- ings and all connecting parts. See Group 32 of the Heavy-Duty Trucks Service Manual for instructions. 1. Inspect the suspension assembly for loose fas- teners, wear, cracks, and damage to its compo- nents. Replace the component(s) if any wear, cracks, or damage exist. If any of these condi- tions exist, replace the damaged bracket(s).

See Group 32 of the Heavy-Duty Trucks Service Manual for instructions. Heavy-Duty Trucks Maintenance Manual, October 2009 32/2