Freightliner — FLA COE, FLB COE, FLC112 Conventional, FLD Conventional, FLL COE

Suspension 32 slowly to the nearest workshop for restrictor can replacement. Hendrickson Walking Beam Suspension, RS Series 1. Inspect the frame hanger to frame attaching fas- teners for the proper torque. See Group 00 of this manual for torque specifications. WARNING Be sure that fasteners are torqued correctly. Fas- teners that do not provide a tightly clamped joint between the frame and the hanger can cause pre- mature fracture of the frame hanger, separation of components, loss of vehicle control, and possible personal injury or property damage. 1 2. Visually inspect each frame hanger for any evi- dence of cracks in the vertical mounting flange. See Fig. 14 . 09/15/95 f320420 2 1.

Crack in Inspection Area Fig. 15, Hendrickson RS Series Horizontal Mounting Flange 4. Visually inspect each frame hanger for severe rust on the horizontal mounting flange adjacent to the vertical drive pin area. See Fig. 16 . 5. Inspect the load cushions for cuts and swelling. See Fig. 17 . Cushions cut by the retaining lips of the saddles or frame hangers indicate the cush- ions may not be the correct hardness or configu- ration for the vehicle operation. 6. Inspect the lower side of the vertical drive bush- ings for evidence of torn or shredded rubber. Check that the concave washers are installed with the lips pointing downward. 09/15/95 f320419 7.

Inspect the saddles and saddle cap fasteners for wear. The allowable thrust washer wear in alumi- num saddles is up to 3/16 inch (4.8 mm) into the saddles as measured at the top of the thrust washer diameter. Check that the locknuts are torqued to specification to prevent wear of the beam center bushings into the legs of the saddles. See Group 00 of this manual for torque specifications. 1. Frame Rail 2. Crack in Inspection Area Fig. 14, Hendrickson RS Series Vertical Mounting Flange 3. Visually inspect each frame hanger for evidence of cracks in the horizontal mounting flange adja- cent to the vertical drive pin area. See Fig. 15 . Heavy-Duty Trucks Maintenance Manual, October 2009 32/8