Suspension 32 1 Hendrickson RT2 and RTE2 Series 1. Park the vehicle on a level surface, apply the parking brakes, and chock the front tires. Raise the rear of the vehicle until the rear wheels are suspended in the air, then support the ve- hicle with safety stands. 2. Check the torque of the number-one spring hanger (double-lock-bolt design) lock bolt nuts. If a loose connection has caused pin hole wear, replace the hanger. 3. Inspect the pin hole in the outboard leg of the number one spring hanger (draw-key design) for wear or elongation.
WARNING Wear at this point requires hanger replacement, or premature fracture of the spring hanger pin may occur, with possible separation of components and loss of vehicle control. This could result in serious personal injury or property damage. 09/15/95 f320421 1. Rust Inspection Area 4. Visually inspect the cam surface of the number- two spring hanger for wear due to operating mileage. Also, inspect the outside legs for wear which can be caused by worn spring eye bush- ings. NOTE: RTE2 (extended-leaf-spring) suspen- sions require a minimum gap of 3/8 inch (9.5 mm) between the cam surface of the number- two spring hanger and the top of the main leaf in the unloaded condition. See Fig. 18 .
If this gap is less than 3/8 inch (9.5 mm), the extended-leaf portion of the spring will not per- form satisfactorily for an empty ride. Fig. 16, Hendrickson RS Series Rust Inspection 5. Inspect the cam surface on the number-three spring hanger (extended-leaf-springs only) for wear. Excessive wear will reduce the gap avail- able at the number-two spring hanger. Refer to the previous note. 6. Place a block of wood on the leaf spring. See Fig. 19 . Place a pry bar on the block of wood and insert the end of the pry bar under the frame hanger. Attempt to lift the frame hanger, as shown in Fig. 19 .
Also, with an empty chassis and the brakes applied, attempt to rock the chas- sis back and forth while observing the spring eye. In either case, if 1/8 inch or more of move- f320318a 05/27/93 Fig. 17, Hendrickson RS Series Load Cushion Inspection Heavy-Duty Trucks Maintenance Manual, October 2009 32/9