Suspension 32 Neway 1 4 WARNING Inspect the components and check their operation as described below. Failure to perform these in- spections and checks could result in separation of worn suspension components and loss of vehicle control, possibly causing personal injury or death, or property damage. A 2 3 1. Park the vehicle on a level surface. Apply the parking brakes and chock the tires to prevent the vehicle from moving. f320112a 05/27/93 A. Minimum gap of 3/8" (9.5 mm). 1. Forward (no. 1) Spring Hanger 2. Spring Eye Pin 3. Rear (no. 2) Spring Hanger 4. Rear (no. 3) Extension 2. Inspect the rear suspension for any signs of damage, loose components, wear, or cracks.
Re- place any damaged components to prevent fail- ure or equipment breakdown. 3. Inspect all bolts and nuts at the pivot and axle connections to assure they are properly torqued. Check all other nuts and bolts for proper torque. See Group 00 of this manual for proper torque specifications. Fig. 18, RTE Suspension (unloaded) ment is observed, the bushing and pin should be replaced. This also could indicate that a broken spring eye and spring are connected to the spring hanger through the wrapper eye of the second leaf. In this case, the main leaf or the complete spring should be replaced immediately. 4.
Check the air pressure gauge to confirm that there is in excess of 65 psi (448 kPa) in the air system, and inspect the air springs for sufficient and equal firmness. NOTE: Height control valves control all air springs. Check for air leaks by applying a soapy solution, then checking for bubbles, at all air connections and fittings. 5. Check the riding height of the air suspension by measuring the distance from the centerline of the rear axle (see Fig. 20 ) to the bottom of the frame rail. If the riding height is incorrect, adjust the air suspension. 4 32–02 Suspension Lubricating 1 Front Suspension 2 Wipe all dirt away from the grease fittings (if equipped) on the spring-eye bushings.
Apply multi- purpose chassis grease with a pressurized grease gun until the old grease is forced out. f320422 08/16/96 3 1. Frame Bracket 2. Leaf Spring 3. Wood Block 4. Pry Bar Fig. 19, Hendrickson RT2 and RTE2 Series Frame Bracket Inspection Heavy-Duty Trucks Maintenance Manual, October 2009 32/10