. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING the engine is stopped and may cause serious burns. Wait for the oil the engine hood. REMARK When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. 3 - 82 Parts temperature to go down befor e performing this operation. 1. Open the front cover in the center of the engine hoo 2. Remove dipstick (G), a nd wipe the oil off with a clot 3. Fully insert dipstick (G) into filler pipe, then remove 4. The oil level should be between the H and L marks o n dipstick ( I ( G).
f the oil level is below t he L mark, add oil through oi l filler port F). 5. I f the oil is above the H mark on the gauge, remove cove r (1), drain the excess oil fro engine oil pan, then ch m drain valve (P) at the bottom of the eck the oil level again. 6. I f oil level is correct, se curely tighten the oil filler cap and close I f the machine is at an ang le, make it horizontal before checking.