. OPERATION MACHINE OPERATIONS AND CONTROLS Check Fuel Level, Add Fuel WARNING 3 - 83 Whe n adding fuel, never let the fuel overflow. This may cause a fire. If any f uel is spill ed, wipe it up compl etely. Never brin g flames near fuel because it is highly flamm 1. 2. I 3. I t 4. f 1. Open fuel filler cap (F) of th e fuel tank. 2. When fuel filler cap (F) is op ened, float gauge (G) comes up in proportion to the remaining fuel level in the tank. ull. isually and with float gauge (G).
screw fuel filler cap (F) on the fuel Check that the fuel tank is f nspect the fuel level both v f fuel is found to be low, un ank and add fuel through t comes up to the highest poi he filler port until float gauge (G) nt. 8.9 US gal) gauge (G) when fuel tank is full: Fuel capacity: 980 liters (25 Position of tip (a) of float Approx 50 mm (2 in) 4. After refilling with fuel, push float gauge (G) straight down with uel filler cap (F) and then ti ghten the cap securely. REMARK I f the fuel tank breather gets clo gged, pressure inside the fuel tank goe s down and fuel may not be s ent, so clean the breather element ever y now and then.
If pressur fuel is not sent even thoug e inside the fuel tank remains low and h the breather has been cleaned, replace the breather element w ith a new one, seeing "REPLACE ENT (PAGE 4-62)". FUE L TANK BREATHER ELEM Drain Water And Sediment from Fuel Tank 1. 2. 3. 4. 1. Set a container under drain hose (1) to catch the drained fuel. 2. Pull out drain hose (1) from t he clip on the chassis and point the hose tip to the container. Open drain valve (2) and drain the sediment and water ogether with the fuel. only clean fuel begins to flow out, ) to the original place. accumulated at the bottom t 4. Close drain valve (2) when and put away drain hose (1