. OPERATION TRANSPORTATION be extended. structure so that it is at 90 ° on the opposite 3 - 147 Increasing Track Gau 1. Remove center fr ame mounting bolt s (2) (o ne side, f ront + rear: 8 bolts) from the f ront and rear of the track frame on the side to 2. side to track fram REMARK Height H of the track f rame being raised should be less t han 50 mm (2 in). Take care no t to raise the track frame so much that the ed. he stopper bolt is distort 3. Using the arm, p ull the machine to t he fro The track frame 4. Extend the track he stopper, then low bolts (1) (one s specified torque. Tightening torqu 5. Follow the same other side.
Stop the mac retracting the t Never operate retracting the they are opera stopper, then low er the machine sl owly to the gro und. Install bolts (1) (one s ide, front + rear: 20 bolts) and tighten to e: 2452 - 3040 Nm (250 - 310 kgm, 1810 - 2245 lbft) procedure to retract the track frame on the hine on firm level ground when extending or rack frame gauge width. the cylinders suddenly when extending or track frame gauge width. It is dangerous if ted suddenly. to specified torque. Tightening torqu e: 2452 - 3040 Nm 1810 - 2245 lbf ground rack frame gauge width. Never operate the cylinders suddenly track frame gauge xtending or tending or angerou if