. OPERATION TROUBLES AND ACTIONS TROUBLES AND ACTIONS RUNNING OUT OF FUEL Procedure for Bleeding Air CAUTION 3 - 154 When sta rting the engine again after run ning out of fuel, fill with fu el, then bleed the air from the fuel system before starting t he engine. Always w atch the fuel level and be care I f the eng ine has stopped because of lac k of fuel, it is necessary to use the priming pump to bleed the air completely from the This en gine consists of higher precision p arts than on the conventional fuel injection pump and noz zle, so if dirt gets in, it wil cause p roblems. If there is any dirt stuck to the fuel line, use fuel to wa sh it off completely.
Be care ful when opening the air bleed plu g at the fuel filter head. The s ystem is still under pressur e and fuel may spurt out. 1. Loos en air bleed plug (A) at the fuel main filter head (1). ) of priming pump (2). 2. Loos en wing nut (4) holding lever (3 3. Push in lever (3) repeatedly. Chec (A). k that bubbles come out with t he fuel from air bleed plug en air bleed plug (A). 4. Tight Tight ening torque: 4.9 to 6.9 Nm (0.5 to 0.7 kgm, 3.6 to 5.1 lbft) 5. Tighten wing nut (4) securely to lock Target tightening torque: 11.8 Nm (1.2 kgm, en wing nut (4) securely to lock et tightening torque: 11.8 Nm lever (3) in position. 8.7 lbft)