Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE the element. 4 - 20 8. I t is checked by shining a lig ht through it after cleaning, replace 9. Remove the cloth or tape c NOTICE lds or gasket or seal are damaged. D o not use an element whose fo If the element or O-ring are clean ed and used again after they have bee n used for m ore than one year, it will c ause problems. D o not use them again. 10. Check that there is no dirt o r oil stuck to the seal portion of the new e lement or clean ed element. Wipe of f any dirt or oil. traight with your hand when installing it to the air cleaner body. 11.

Push the outer element in s traight with your hand when installing it t o the air cleaner I f the outer element is held a nd rocked lightly up and down and to the left and right wh ile pushing it in, the outer element can be inserted ea sily. NOTICE Whe n inserting the element, if the r ubber at the tip is swollen or the outer element is not pushed in straight, a nd cover (3) is assembled by force to hook (2), there is danger that the hook and air cleaner body may be mbling. damaged, so be careful when asse 12. I nstall cover (3) as follows. element. ) to the protruding part of the air in position.

1) Align cover (3) with the 2) Hook the tip of hook (2 cleaner body and lock it 3) When locking hooks (2) on opposite sides (top, as when tightening bolt 4) Always install cover (3) the ground (A). 5) When cover (3) is ins between the air cleaner If it is too large, install a 1) Align cover (3) with the 2) Hook the tip of hook (2 3) When locking hooks (2) in position, apply the hooks in turn bottom, left, right) in the same way s. 4) Always install cover (3) so that the evacuator (4) is facing talled, check that the clearance body and cover (3) is not too large. gain. t, push the indicator button at the reset it. 13. When replacing the elemen bottom of the air cleaner to