. MAINTENANCE MAINTENANCE PROCEDURE WARNING 4 - 24 Antifreeze is toxic. When open th e drain valve, be careful not to get w ater containing antifreeze on y ou. If it gets in your eyes, flush your eyes with large amoun t of fresh water and see a doctor at once. When changing the coolant or dr aining the coolant from the radiator before carrying out repairs, as k a specialist company to handle any coolant containing a ntifreeze, or contact your Komatsu distributor. Antifreeze is toxic, so never pour it into onto the ground surface. drainage water ditches or drain it The coolant is already diluted wi th distilled water.
(For details of the distilled water, see "CO OLANT AND WATER FOR DILUTION (PAGE 4-5)". C heck the density with a coolant tester. Prepare a container whose cap acity is larger than the specified coolant volume to catch dr Prepare a hose to use when filli 1. Stop the engine. 2. Remove the cover (1) and tu rn radiator cooling water filler c (2) slowly to take it off. 3. Remove covers (3) and (4), and place a container to recei antifreeze- mixed cooling wa the lower part of the radiato ter under drain valve (5) located r and also under engine cooli water drain valve (6) located pan. 4. 5. Open drain valves (5) and (6 After draining the antifreeze then fill with clean water.
Aft er the radiator is filled with wat start and run the engine at temperature rises above 9 about 10 minutes. 6. Stop the engine and open dr ain valves (5) and (6) to drain t water. 7. After draining the water, cle When carrying out the instructions given with the fl 8. Close drain valves (5), (6). 9. Install the covers (3) and (4) 10. Add Supercoolant through t he water filler up to the bottom o For details of the Supercool ant density, see the COOLANT 11. Run the engine at low idling for 5 minutes to remove the air f rom the water, then run at hi gh idling for 5 minutes. ( Leave radiator cap (2) rem oved when doing this. )