Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%.

Supercoolant (AF-NAC) is already diluted with distilled water. When using coolant, investigate the lowest temperatures in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it for a temperature 10 ° C (18 ° F) lbelow the actual temperature. The coolant density varies according to the ambient temperature, but it must always be a minimum of 30%. Coolant density table 4 - 23 Immediately after t he engine i s stopped, t he coolant i s at a high temperature and th e radiator is under high interna l pressure. If the c ap is r emoved to drain th e coolant in this condition, t here i s a hazard of burns.

Wait for the temperature to go down , then turn th e cap slowly to release the pressur e before removin g it. Cleani ng is c arried o ut with the engine running. When standing u p or leaving the op erator's seat, set the lock lever t o the LOCK positi on. For de tails o f startin g the engi ne, see"BEFORE STARTING ENGI NE (PAGE 3-79)" an d "STARTING ENGINE (PAGE 3 -98)" in the OPERATION section . ouching the fan if the undercover is left removed. the machine when the engine is running.

There is danger of t ouching th e fan if the undercover is lef t removed Never enter behind the machin e when the engine is r unnin Stop the machine o n level gr ound when cleaning or changi ng the Clean th e inside of t he coolin g system, change th e coolant according t o the table below Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Minimum Temp °C Above -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Above 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 30 36 41 46 50 54 58 61 64