Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 22 8. Replace O-ring ( 8) of cover (3) with a Whe n inserting the ele ment, if the rubber at the tip is swollen o r the outer element is not pushed in straight, and cover (3 ) is assembled b y force to hook (2), there is dan ger that the hook and damaged, so be careful 9. I nstall cover (3) a s follows. 3) with the element. of hook (2) to the protruding part of the air and lock it in position.

1) Align cover ( 2) Hook the tip cleaner body 3) When locking on opposite s as when tigh 4) Always instal the ground (A 5) When cover between the If it is too larg 1) Align cover ( 2) Hook the tip of hook (2) to the p and lock it in positio 3) When locking hooks (2) in position , apply the hoo ks in turn ides (top, bottom, lef t, right) in the s ame way tening bolts. 4) Always instal l cover (3) so that th e evacuator (4) is facing ). (3) is installed, check that the clearance 5) When cover learance air cleaner body and cover (3) is not too large. e, install again. 10.

After replacing th e element, press res et button (9) of the dust i ndicator to retur n the yellow display t o its original po sition.