Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CAUTION When starting the engine to bleed the air, cancel the automatic warming-up operation before starting. 2. Starting engine Cancel the automatic warming-up operation before starting the engine. Run the engine at low idling for 10 minutes after starting it, then go on to the next operation. 3. Bleeding air from cylinders 2) Next, operate each cylinder 3 to 4 times to the end of its stroke. 4 - 38 BLEEDING AIR FROM HYDRAULIC SYSTEM For details of the procedure when starting the engine, see "STARTI NG ENGINE (PAGE 3-98)".

If necessary , refer to the OPERATION volume for the sections for starting the engine, moving the machine off, steering, and sto pping. NOTICE Bleed the air as follows. 1. Pump (work equipment, swing) 2. Work equipment circuit to the end of the stroke. g), operate particularly slowly. Run the engine at less than 1000 rpm, and operate the cylinders slowly. Do not suddenly stop and cause the cylinder pressure to rise or operate When operating the cylinder for the first stroke (extending and retractin When operating the cylinder for the first stroke, there is a large amount o f air inside the circuit, so the work equipment will not move for at least 10 seconds.

Be careful not to operate the lever to the end of the stroke. use a clean oil can. Use clean oil of NAS7 class or above when filling the pump. Be sure to Carry out Steps 1 - 3 below to bleed the air. If necessary, carry ou t Steps 4 - 6 in addition. 1. Bleeding air from pump 1) Loosen air bleed plug (1) and check that oil oozes out from the air bleeder (3). 2) If oil (4) does not ooze out, remove the pump case drain hose and elbow, then fill the inside of the pump case with hydraulic oil through drain port (2).

If the mouthpiece is lower than the surface of the oil in the hydraulic tank, oil will flow out from the drain hole when it is removed, so secure the mouthpiece of the hose at a position higher than the level of the oil in the hydraulic tank. 3) After completing the air bleed operation, tighten air bleeder (1) and install the drain hose. NOTICE If the drain hose is installed first, oil will spurt out from plug (1) hole. If the pump is operated without filling the pump case with hydraulic oil, abnormal heat will be generated and this may cause premature damage to the pump. inder 4 to 5 times, taking care that a cylin der is x. 100 mm (3.9 in) short of its stroke end