Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 39 each cylinder 4 to 5 times to t he end of it s stroke to comple tely remove the If the engine is run at high s peed immediately after startup or a cylinder is pushed up to its stro ke end, air taken in side the c ylinder may cause damage to the 4. Bleeding air from swing motor (bleed the air only when the oi When oil has been drained from inside swing motor case 1) Run the engine at low idling, loosen hose (1), and chec that oil oozes out from hose (1). NOTICE Do not operate the swing under any circumstances. 4.

Bleeding air from sw ing motor (bleed the air only when the oi l inside the swing motor case has been drained) n drained from inside swing m otor case k , Do not operate the swing u 2) If oil does not ooze out, stop the engine, remove hose (1) and fill the inside of the motor case with hydraulic oil. ze out, stop the engine, remo ve hose (1) e of the motor case with hydra bleeding the air, tighten hose (1). t low idle, and slowly swing th e upper stru cture at least 2 tim es uniformly to th e left and right. NOTICE the swing motor, the motor bearings may be damaged.

If the air is not bled from the swing motor, the motor bea rings may be Use the above procedur e also to bleed the air when the s wing motor s afety valve has bee 5. Bleeding air from att achment (when installed) If an attachment ha (approx. 10 times) u s been installed, run the engin e at low idli ng and operate th e attachment pe dal repeatedly ntil the air has been bled from the attach ment and circuit. NOTICE If the method of bleedin g the air from the attachment its elf is specifi ed by the manufactu rer, bleed the air according to the specified procedure. After completing the air bleeding operation, stop the eng ine, and leav e the machine for 5 minutes before sta rting operations.

This will remove the air bubbles in the oil inside the hydr aulic cylinde rs. spilled. Check that there is no le akage of oil and wipe off any oil that has been