. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE (2) one turn. out from air bleed lever and set to wait for at least 5 minutes before starting 4 - 40 6. Bleeding air from travel mot f t he piping has been remo oto rcuit, bleed the ai r after reassem bling. To bleed the air, run the s follows. at low idling. air, run engine at lo w idling and do a 1) Start the engine and run at low idling. 2) Remove travel motor co ver (1), then lo osen a ir bleed plug NOTIC Do not loosen plu g (2) more than on 3) plug (2), tighten air blee 4) Carry o ut fine operatio n of the trav FORWA RD and REVER SE 4 - 5 time 5) Install th e travel motor c 7. 1) After co ngine operatio ns.
This will allo w the bubbles in the o il insid e the tank 2) Check th at there is no le akage of oil, a nd wip e up an y oil t hat h