Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE EVERY 250 HOURS MAINTENANCE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 45 Maintenance for every 10 hours ser vice shoul d be carrie d out at the same time The parts and o il are at high tempera ture immediately after t he engine is stopped , and may cause serious burns. W ait fo r the temperature to go down before starti ng the operation. If there is still p ressure remaining ins ide the case , the oil or plug may fly out. Loosen the plug slowly to release th Prepare a han dle. mark at the top, with the UP mark and plug (P r to the ground surface. 1. 2. 3. 4. 5. 1. Set the TOP perpendicula r to the ground sur 2.

Using a hand le, remove plug (F ) and chec k that the oil level is within a rang e of 10 mm (0.4 in) below the bottom ed ge of the plug hole. 3. If the oil leve l is low, check agai n. Install p lug (F), op erate the travel lever, t ravel in FORWAR D or REVERSE, and rotate the sprocket one turn. Perform ins pection for Procedure 2 again 4. If the oil leve l is low, add engin e oil throug h plug hol e (F) unti the oil overfl ows from plug hole (F). 5. After checkin g, install plug (F) Tightening to rque : 93.1 - 122.5 Nm (9.5 - 12.5 kgm, 68.7 - 90.4 Nm (9.5 - 1 2.5 kgm, 6 8.7 - 90.4 lbft)