. MAINTENANCE MAINTENANCE PROCEDURE CHECK AND TIGHTEN TRACK FRAME AND AXLE CONNECTING BOLTS they Tightening torque: 2746 ± 294 Nm (280 ± 30 kgm, 2030 ± 220 lbft) CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST running for 1 hour. 4 - 48 Bolts (1 remain ) connecting the track loose, so loose bolts m frame and axle will break i ust always be retightened. Checkin g The standard deflection for the drive belt is (A) when presse d with a thum b (at approx. 58.8 N { approx. 6 kg}) at a point midway ernator pulley (1). idway betwee n drive pulley (2) and alt (A): 10 - 15 mm (0.4 - 0.6 in) Adjustment 1. Loosen bolts and nuts (3) - alternator. If nut (6) is tightened, the is loosened, the belt will 2.
After adjusting the belt, ti reverse number order from 1. Loosen bolts and nuts (3) - (5) in number order, and mo ve the alternator. If nut (6) is tightened, the belt tension will increase; if nut (6) loosened, the belt will become loose. ghten bolts and nuts (3) - (5) in (5) to (3). 2. Afte r adjusting the belt, ti reverse number order from w n ear of the V-belt. Chec k in particular that the V-belt does the V-groove. ot contact the bottom of If the V-belt is elongated and there is no more allowan ce for a djustment, or if the belt is cracked or cut, replace th e belt. W hen the V-belt has b een replaced, adjust again after