. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Adjustment compressor. If nut (9) is tightened, the belt tension will increase; if nut (9) is loosened, the belt will become loose. 2. After adjusting the belt, tighten bolts and nuts (6) - (8) in reverse number order from (8) to (6). Check each pulley for damage, wear of the V-groove, and 4 - 49 Checking nd (3), then remove cover (1). 1. 2. 1. Remove bolts (2) a nd (3), then remove cover ( 2. The standard defle ction for the drive bel t is (A) when p ressed with a thumb [at approx. 58.8 N (approx. 6 kg] at a point drive pulley (4) and air conditioner (5).
4 - 0.6 in) kg] at a point midway between compressor pulley (A): 10 - 15 mm (0. 1. Loosen bolts and n uts (6) - (8) in numbe r order , and m ove the wear of the V-b not contact the elt. Check in particula bottom of the V-groov r that the V-belt does e. If the V-belt is el ongated and there is no more allowance for adjustment, or if the belt is cracked or cut, re place t he belt. When the V-be running for 1 ho lt has been replaced, adjust again after ur. 3. Install cover (1).